Intel Desktop Board D101GGC Technical Product Specification
1.9 LAN Subsystem
The LAN subsystem consists of the following:
•
Realtek 8101L LAN adapter device for 10/100 Mbits/sec Ethernet LAN connectivity
•
RJ-45 LAN connector with integrated status LEDs
•
Programmable transit threshold
•
Configurable EEPROM that contains the MAC address
Two LEDs are built into the RJ-45 LAN connector (shown in Figure 4).
Table 5 describes the LED states when the board is powered up and the 10/100 Mbits/sec LAN
subsystem is operating.
Table 5.
LAN Connector LED States
LED Color
LED State
Green
Off
On
Blinking
Yellow
Off
On
1.9.1 LAN Subsystem Software
LAN software and drivers are available from Intel's World Wide Web site.
For information about
Obtaining LAN software and drivers
22
Green LED
Figure 4. LAN Connector LED Locations
Condition
LAN link is not established.
LAN link is established.
LAN activity is occurring.
10 Mbits/sec data rate is selected.
100 Mbits/sec data rate is selected.
Yellow LED
OM15076
Refer to
Section 1.2, page 14