Table of Contents
Advertisement
INSTALLATION
Removal of transport bracket
The washing machine is fitted with a transport bracket to
avoid any possible damage during transport.
IMPORTANT: Before using the washing machine, the
transport bracket at the back MUST be removed.
1. Unscrew the two screws "A" and the four screws "B"
with a flat screwdriver or a No. 8 hex nut box spanner.
2. Remove the transport bracket.
3. Replace the four outer screws "B" on the machine and
tighten them.
4. Clip the two seals "C" supplied into the openings "D"
of the washing machine.
Note: do not forget to replace and tighten the four
outer screws.
Adjust the feet
Install the washing machine on a level surface, near to
electrical, water and drain connections.
If the floor is uneven, adjust the feet (do not insert pieces
of wood, cardboard etc. under the feet):
1. Loosen the locknut using the wrench provided.
2. Adjust the height of the feet by hand.
3. Retighten the locknut by turning it anti-clockwise.
Make sure that the feet are resting correctly on the
floor and that the washing machine is perfectly level
and stable (use a spirit level).
The washing machine can be installed in an area 40 cm wide
and 63 cm deep.
Note: if you install the machine on thick carpet, adjust the
feet to ensure that there is sufficient space under the
machine for the air to circulate.
B
GB 3
A
1\3
2
C
D
4
Hide quick links:
Advertisement
Table of Contents
