Samsung HT-E4200 User Manual page 47

• CT (Clock Time) : Decodes the real time clock
from the FM frequency. Some stations may not
transmit PTY, RT or CT information therefore
this may not be displayed in all cases.
• TA (Traffic Announcement) : TA ON/OFF it shows
that the traffic announcement is in progress.
| NOTE |
\ RDS may not operate correctly if the station tuned is not
transmitting RDS signal properly or if the signal strength
is weak.
To show the RDS signals
You can see the RDS signals the station sends on
the display.
Press the RDS DISPLAY button while listening to
an FM station.
• Each time you press the button, the display
change to show you the following information :
PS NAME RT CT Frequency
While searching, <PS NAME> appears
PS
and then the station names will be
(Program
displayed. <NO PS> appears if no
Service)
signal is sent.
While searching, <RT> appears and
RT then text messages the station sends
(RadioText)
will be displayed. <NO RT> appears if
no signal is sent.
Frequency
Station frequency (non-RDS service)
About characters shown in the display
When the display shows PS,or RT signals,the
following characters are used.
• The display window cannot differentiate upper
case and lower case letters and always uses
upper case letters.
• The display window cannot show accented
letters, <A,> for instance, may stands for
accented <A's> like <À, Â, Ä, Á, Å and Ã.>
PTY (Program Type) indication and
PTY-SEARCH function
One of the advantages of the RDS service is that
you can locate a particular kind of program from
the preset channels by specifying the PTY codes.
To search for a program using the PTY
codes
K
Before you start!
• The PTY Search is only applicable to preset
stations.
• To stop searching any time during the process,
press 5 button while searching.
• There is a time limit in doing the following steps.
If the setting is cancelled before you finish, start
from step 1 again.
• When pressing the buttons on the primary
remote control, make sure that you have
selected the FM station using the primary
Usin
remote control.
RDS DISPLAY
1 2 2
PTY- PTY SEARCH
4 5
1 · Press the PTY SEARCH button while
listening to an FM station.
2 · Press the PTY- or PTY+ button until the PTY
code you want appears on the display.
• The display gives you the PTY codes
described to the right.
3 · Press the PTY SEARCH button again, while
the PTY code selected in the previous step is
still on the display.
• The centre unit searches 15 preset FM
stations, stops when it finds the one you
have selected, and tunes in that station.
TA
3
PTY+
6
47
|
English