Sanyo PDG-DWT50L - WXGA DLP Projector User Manual page 19

1. Introduction
I L
TEM ABEL
SCREEN
10.
TRIGGER
11.
S-VIDEO
12.
POWER SWITCH
13.
AC IN
AUDIO IN
14.
[L(MONO)/R]
(VIDEO)
15.
VIDEO IN
COMPONENT IN
16.
(Y, Cb/Pb, Cr/Pr)
COMPUTER 2 IN
17.
(R/Cr, G/Y, B/Cb,
H, V)
18.
COMPUTER 1 IN
AUDIO IN
19.
(COMPUTER 1)
20.
LAN
21.
SERVICE
Note:
To use this feature, you must turn on the Screen Trigger function on the OSD.
Screen controllers are supplied and supported by screen manufacturers.
Do not use this jack for anything other than intended use. Connecting the wired remote control to the
Trigger mini jack causes damage to the remote control.
When connected to the screen through a commercially available
cable, the screen deploys automatically on start up of the projec-
tor. The screen retracts when the projector is powered off
(see notes below)
Connect a commercially available S-video cable from a video
device
Turn on/off the projector
Connect the supplied power cable
Connect RCA audio cables (not supplied) from the input device
right and left channels. This audio jack is shared with S-Video
input.
Connect a composite video cable (not supplied) from a video de-
vice to the yellow RCA jack
Connect a component video enabled device
Connect RGBHV or Component signal from computer or com-
ponent video enabled device
Connect a VGA cable (supplied) from a computer
Connect the audio cable (not supplied) from the input device
Connect a LAN cable (not supplied) from a computer
Connect the USB cable (not supplied) from a computer. For ser-
vice personnel only.
D
ESCRIPTION
10
S P :
EE AGE
117
30
32,41
31
—
30
29
26
26
—
—
—