Testing Connectivity; Presenting Iscsi Hosts As Virtual Fibre Channel Hosts; Host Side: Iscsi Initiator Configuration; Iscsi Initiator Properties Window - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Testing connectivity

To test connectivity, issue the ping command from the host (ping the C-Series Fibre Channel switches)
and the switches (ping the server's two IP addresses). If host and switches are able to ping each other's
respective IP addresses you can proceed with the final steps.

Presenting iSCSI hosts as virtual Fibre Channel hosts

After establishing IP connectivity, you must configure the host and switches for iSCSI discovery and login.
Host side: iSCSI Initiator configuration
You must specify the iSCSI targets that the host will access.
1.
Double-click the Microsoft iSCSI Initiator icon to open the iSCSI Initiator Properties window
(Figure 25).
Figure 25 iSCSI Initiator Properties window
2. On the Discovery Tab, click Add under Target Portals.
The Add Target Portal window opens (Figure 26).
C-Series iSCSI 33