Removing And Installing Expansion Modules; Installing An Expansion Module - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Chapter 2 Installing the Cisco Nexus 5000 Switch
S e n d d o c u m e n t a t i o n c o m m e n t s t o n e x u s 5 k d o c s @ c i s c o . c o m

Removing and Installing Expansion Modules

To prevent ESD damage, wear grounding wrist straps during these procedures and handle expansion
Caution
modules by the carrier edges only.
Install the Cisco Nexus 5000 switch in the rack before installing expansion modules. For information
Note
about installing the chassis, see the
section on page 2-5
page 2-8
This section includes the following topics:
•
•

Installing an Expansion Module

To install an expansion module, follow these steps:
Grasp the handle of the module and place your other hand under the module to support it.
Step 1
Gently slide the module into the opening until you cannot push it any further.
Step 2
Step 3 Tighten the captive screw on the front of the module.
Figure 2-9
OL-15902-01
or "Installing the Cisco Nexus 5010 Chassis in a Cabinet or Rack" section on
Installing an Expansion Module, page 2-19
Removing an Expansion Module, page 2-20
shows the positioning of an expansion module in the 5020 chassis.
"Installing the Cisco Nexus 5020 Chassis in a Cabinet or Rack"
Cisco Nexus 5000 Series Hardware Installation Guide
Removing and Installing Components
2-19