Checking Leds; Setting The Ip Address - Cisco 9124 - MDS Fabric Switch User Manual

Checking LEDs

See Figure 6 to locate power-on LEDs.
Figure 6 Verifying power-on LEDs
Verify that the LEDs match the indicators described in
Table 7 Power-on LEDs
Item Description
1
UID LED
module in the BladeSystem for replacement,
etc.
2 Health ID LED

Setting the IP address

Obtain the following items to set the IP address via a serial connection:
• Computer with a terminal application (such as HyperTerminal in a Windows environment or
TERM in a UNIX environment
• Null modem serial cable
Set the IP address:
1. Verify that the enclosure is powered on.
2. Identify the active OA in the BladeSystem.
3. Connect a Null modem serial cable from your computer to the serial port of the active OA.
4. Configure the terminal application as follows:
• In a Windows environment:
• Baud rate—9600 bits per second
• 8 data bits
• None (No parity)
• 1 stop bit
• No flow control
1
EXT 1
!
:
2
- used to help user locate a specific
EXT 2 EXT 3 EXT 4
Table 7.
Indicators
Off
Steady green light
Cisco MDS 9124e Fabric Switch for HP c-Class BladeSystem 21