Cisco MDS9120 - MDS 9120 Multilayer Fabric Switch Installation Manual page 52

Installing the Switch in a Cabinet with Insufficient Front Clearance
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Note
a. Route the power cord through the open cutout at the end of one of the slider rails, and then let the
cord dangle while you proceed with the next steps.
through the open cutout in the slider rail.
b. Position one of the slider rails against the front rack-mounting rails and align the screw holes as
shown in
the rack rail thread type. For racks with square holes, first install the 12-24 cage nuts.
Repeat with the other slider rail on the other front side of the rack.
c.
Use the tape measure and level to verify that the rails are horizontal and at the same height.
d.
Figure 2-13
Cisco MDS 9100 Series Hardware Installation Guide
2-18
When installing the Cisco MDS 9148 Switch, Cisco MDS 9134 Switch or the Cisco MDS 9124
Switch rear-facing into a cabinet, do not install it higher than RU-30.
Figure 2-13. Then attach them using two 12-24 screws or two 10-32 screws, depending on
Installing the Notched Slider Rails to the Front Rack-Mounting Rails
Chapter 2 Installing the Cisco MDS 9100 Series
Figure 2-15 shows a power cord correctly routed
OL-21514-01