Cable And Port Specifications; Cables And Adapters - Cisco MDS9120 - MDS 9120 Multilayer Fabric Switch Installation Manual

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Cable and Port Specifications

This appendix includes the cables and connectors used with the Cisco MDS 9100 Series Fixed
Configuration Fabric Switch, and it includes the following sections:
•
•
•
•
We strongly recommend that power cable runs and other potential noise sources be located as far away
Caution
as practical from network cabling that terminates on Cisco equipment. In situations where long parallel
cable runs exist but cannot be separated by at least 3.3 ft. (1 m), we recommend that you shield these
potential noise sources. To avoid interference, the source should be shielded by housing it in a grounded
metallic conduit.

Cables and Adapters

The Cisco MDS 9100 Series accessory kit includes the following:
•
•
•
•
Additional cables and adapters can be ordered from your customer service representative.
Note
If you purchased this product through a Cisco reseller, contact the reseller directly for technical support.
Note
If you purchased this product directly from Cisco, contact Cisco Technical Support at this URL:
http://www.cisco.com/cisco/web/support/index.html.
OL-21514-01
Cables and Adapters, page C-1
Console Port, page C-2
MGMT 10/100 Ethernet Port, page C-3
Supported Power Cords and Plugs, page C-4
RJ-45 to RJ-45 rollover cable
RJ-45 to DB-9 female DTE adapter (labeled "Terminal")
RJ-45 to DB-25 female DTE adapter (labeled "Terminal")
RJ-45 to DB-25 male DCE adapter (labeled "Modem")
A P P E N D I X
Cisco MDS 9100 Series Hardware Installation Guide
C
C-1