1. Send the appropriate control commands from the computer to print on
validation paper.
When the VALIDATION/SLIP light flashes, insert a sheet of validation
2.
paper into the validation paper inlet (see the illustration below);
printing will then begin.
Make sure you insert the validation paper into the inlet as far as it will go.
Note:
When the
application software), remove the paper from the paper path.
Replacing the Paper Roll
To change the paper roll, follow the steps below.
1. Cut the journal paper on the cutter; then remove the take-up spool.
VALIDATION/SLIP
light flashes (this depends on the
Using the Printer 2-5