After Dishwashing - Asko D5554 Operating Instructions Manual

Dishwashing
Stopping or changing a program
If you want to change programs after starting the
dishwasher, open the door then press and hold
Start/Stop for three seconds. Add more detergent if
the lid of the detergent dispenser has opened. Then
choose a new program, press Start/Stop, and close
the door.
Do you want to add more dishes?
Open the door. The dishwasher stops automatically.
Add the dishes, close the door, and the dishwasher
resumes the program.
If the dishwasher is turned off using the
main power switch or due to a power
failure
If the program was not finished, the interrupted
program resumes when power is restored.
NOTE!
During drying, the program is interrupted if the power
is cut or the door is open for more than 2 minutes.
20
8

After dishwashing

Once the program has finished, "End" appears
on the display.
A buzzer also sounds at the end of the program. See
the section Settings, which describes how to change
this function.
A status light also indicates the end of the program.
See the section Status light.
Once the dishwasher has finished, it uses only
standby power. Turn off the dishwasher using the
main power switch if you want to completely cut the
power. Turn off the water supply valve after each use.
Customer Care Center
1-800-898-1879
www.askousa.com