Dell OptiPlex E1 Reference And Installation Manual page 136

WARNING: Could not con-
figure Plug and Play Card
Name .
WARNING: Could not con-
figure PCI device,
ID= DeviceID .
Failed to configure Num-
ber of Total Count Plug
and Play ISA devices. Use
your system's configura-
tion utility to resolve
conflicts. Press any key
to continue.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User's Guide .
B-8 Dell OptiPlex E1 Managed PC Reference and Installation Guide
FRQWLQXHG
The card(s) mentioned
are not fully configured
due to resource conflicts.
If you have documentation that lists the
allowable resource values for your Plug and
Play or PCI expansion card, you can use
the following procedure to locate and
resolve the resource conflict.
NOTE: If you do not have documentation
listing the allowable resource values, see
the corrective action for these messages
on the following page.
Any Plug and Play or PCI expansion
cards that could not be configured
should be marked config err on the
list of cards in the ICU window.
The System Resource Usage dialog
box displays all resources currently
used by the system.
The Card Resources Usage dialog box
identifies which device is using the
resource.
See "Modifying a Card" in Chapter 3
for instructions.