HP dx7500 - Microtower PC Hardware Reference Manual page 42

Microtower model business pc

Hide thumbs Also See for dx7500 - Microtower PC:

Table of Contents

Slide the new drive into the hard drive cage (1), aligning the drive with the four screw holes on the

cage. Install the four 6-32 standard screws that secure the hard disk drive to the hard drive cage

(2). Make sure the hard disk drive cables are facing the top of the drive cage.

NOTE:

old drive to install the new drive.

NOTE:

are installed on the interior of the front bezel. The 6-32 screws are silver. Refer to

Additional Drives on page 24

Figure 2-31

Chapter 2 Hardware Upgrades

If you are replacing an old drive with a new drive, use the four retainer screws from the

If you are installing a second hard drive, use four of the extra standard 6-32 screws that

for an illustration of the retainer screws location.

Installing the Hard Drive in the Drive Cage

Installing

ENWW

Table of Contents

Compaq dx7500