b.
If you are removing a media card reader, disconnect the USB cable from the system board.
Figure 2-23
7.
Remove the two retainer screws that secure the drive to the bay (1) then slide the drive forward
and out of the bay (2).
Figure 2-24
NOTE:
To install an external 3.5-inch drive, refer to
Bay on page
30
Chapter 2 Hardware Upgrades
Disconnecting the Media Card Reader Cable
Removing a 3.5-inch Device (Media Card Reader Shown)
31.
Installing a Drive into the 3.5-inch External Drive
ENWW