Replacing The Hard Disk Drive - Lenovo 6136A1U User Manual

Replacing the hard disk drive

Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the hard disk drive if your
computer has one. For computer models that do not have an internal hard disk
drive installed and use a remote hard disk drive accessed through the SMC -
Storage Array, contact your network or storage administrator.
Important
When you receive a new hard disk drive, you also receive a set of Product
Recovery discs. The set of Product Recovery discs enables you to restore the
contents of the hard disk drive to the factory-installed state. For more
information on recovering factory-installed software, refer to Chapter 3,
"Recovery information," on page 35.
To replace the hard disk drive:
1. Open the computer cover. See "Opening the computer cover" on page 12.
2. Disconnect the power cable from the optical drive.
3. Place your finger on the tab located on the front of the hard disk drive and
push upward. Then press inward on the side tabs and pivot the hard disk
drive upward to remove.
Figure 8. Removing the hard disk drive
4. Remove the failing hard disk drive from the chassis.
5. Disconnect the signal cable and the power cable from the hard disk drive.
6. Remove the hard disk drive from the plastic bracket by flexing the sides of the
bracket enough to slide it free of the hard disk drive.
Chapter 2. Installing options and replacing hardware
15