TomTom RIDER 2nd Edition User Manual page 7

Chapter 3
Using your TomTom RIDER
Using your TomTom RIDER
Switching on
1. Open the compartment on the bottom of your TomTom RIDER.
2. Push the memory card into the memory card slot.
3. Press and hold the On/Off button for 2 seconds, or until your
TomTom RIDER starts.
The first time you switch on your TomTom RIDER, it may take up to 20
seconds to start. To switch off your TomTom RIDER, press and hold the On/
Off button for 2 seconds.
Setting up
First, you have to answer a few questions to set up your device and your
Bluetooth headset module. Answer the questions by tapping the screen. You
will use the touchscreen for everything you do with your TomTom RIDER.
Follow the instructions to establish a Bluetooth connection between your
TomTom RIDER and your Bluetooth headset module.
See the Bluetooth headset module section below for more information about
your Bluetooth headset module.
Once you have answered the questions, your TomTom RIDER will display the
Driving View.
The screen is shown in black and white until your TomTom RIDER locates
your current position. Once this is done, the Driving View is shown in full
color.
Locating your current position
Your TomTom RIDER must be outside to be able to locate your current
position. The first time you start your RIDER, it takes up to 5 minutes for the
device to find your current position.
In future, your position will be found much faster, normally within a few
seconds. If your RIDER takes longer than 5 minutes to locate your current
•
•
•
7
•
•
•