Legacy Mode; Native Mode; Service Reference Guide - HP dx2700 - Microtower PC Service & Reference Manual

Serial ATA Drive Guidelines and Features

4.5.1 Legacy Mode

The Legacy mode is used to access devices attached to an embedded SATA controller. Each
channel of the controller requires two fixed I/O address ranges and an IRQ.
■
Primary Channel
❏
Command block: 1F0h - 1F7h
❏
Control block: 3F6h
❏
IRQ: 14
■
Secondary Channel
❏
Command block: 170h - 177h
❏
Control block: 376h
❏
IRQ: 15

4.5.2 Native Mode

The native mode is used to access devices attached to additional SATA controllers and is not
supported by many legacy operating systems. Addresses are assigned by PCI Plug-n-Play BIOS
and the IRQ is shared with multiple controllers. Base Address Registers for the Command and
Control Block are found in the PCI Configuration Space.
■
Offset 10h—Primary Command base address
■
Offset 14h—Primary Control base address
■
Offset 18h—Secondary Command base address
■
Offset 1Ch—Secondary Control base address
4–4 431672-001

Service Reference Guide