Access Point Layout And Connectors - Cisco 1242AG - Aironet - Wireless Access Point Hardware Installation Manual

Deploying the Access Points on the Wireless Network
Step 4 For lightweight access points, after your access points are deployed, ensure that your controller is not
configured as a master controller. A master controller should only be used for configuring access points
and not in a working network.

Access Point Layout and Connectors

Figure 2-1
Figure 2-1
1
2
3
4
5
Figure 2-2
Figure 2-2
1
2
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
2-6
illustrates the 2.4-GHz connector end of the access point.
Access Point 2.4-GHz Connector End
STATUS
RADIO
ETHERNET
2.4 GHz LEFT
1
2.4-GHz antenna connector (left)
Ethernet LED
Radio LED
Status LED
MODE button
illustrates the 5-GHz connector end of the access point.
Access Point 5-GHz Connector End
LEFT
3 1
5-GHz antenna connector (left)
5-GHz antenna connector (right/primary
CONSOLE
MODE
2 3 4 5 6
6 Console port (RJ-45)
7 Ethernet port (RJ-45)
8
48-VDC power port
9 2.4-GHz antenna connector (right/primary)
5 GHz ANTENNA w/RP-TNC
3
Security key slot )
Chapter 2 Installing the Access Point
ETHERNET
48VDC
2.4 GHz RIGHT/PRIMARY
7 8
RIGHT / PRIMARY
2
9
OL-8371-05