Table of Contents
Advertisement
Chapter 2
Installing the Access Point
Warning
In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a
minimum of 7.9 inches (20 cm) or more from the body of all persons. Statement 332
Unpacking the Access Point
Follow these steps to unpack the access point:
Open the shipping container and carefully remove the contents.
Step 1
Return all packing materials to the shipping container and save it.
Step 2
Step 3
Ensure that all items listed in the "Package Contents" section are included in the shipment. Check each
item for damage. If any item is damaged or missing, notify your authorized Cisco sales representative.
Package Contents
Each access point package contains the following items:
•
•
•
•
•
•
OL-8371-05
Cisco Aironet 1240AG Series Access Point or Cisco Aironet 1240AG Series Lightweight Access
Point
Cisco Aironet 1240AG Series Power Module (universal power module)–optional
Mounting hardware kit
One mounting plate with cable security bracket
–
Two suspended ceiling T-rail clips, spacers (accommodates standard and recessed T-rails), and
–
nuts.
One security hasp
–
Two 6 x 32 x 1/2 in. pan head Phillips machine screws
–
Four 8 x 18 x 3/4 in. pan head Phillips sheet metal screws
–
Four #8 plastic wall anchors
–
–
One 10 x 24 nut (for ground stud on mounting bracket)
–
Four rubber foot pads
–
Two cable tie wraps
Product quick start guide
Product translated safety warnings document
Cisco product registration and Cisco documentation feedback cards
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
Unpacking the Access Point
2-3
Advertisement
Table of Contents
Troubleshooting
