Ricoh Priport DX 4640PD Operating Instructions Manual page 212

Remarks
• Remove the paper from the tray before relocating the machine. If you relocate
the machine leaving the paper on the tray, reset the paper after the relocation.
If the main switch of the machine is turned on without resetting the paper cor-
rectly, the sensor might be broken.
• If the printed paper is stored for more than one day, the paper may become
wrinkled. If this paper is used, wrinkles may also appear on the master. If the
paper will be stored for more than one day, store it in its original wrapping
paper or other protective covering.
• Shadowing may occur if the printed image at the rear edge of the paper is a
solid colour, when the printing speed is set to 1. If this occurs, print the image
with the printing speed set to 3.
• If there are fine lines within 5 mm to 10 mm, 0.2" to 0.4" of the edge of the im-
age, shadowing may occur.
• Depending on the type of paper being used, speckles may appear within 5
mm to 10 mm, 0.2" to 0.4" of the edge of the image at around 1000 prints.
• When two or more sheets of paper feed at once, set paper on the paper feed
side plates securely. See p.35 "Using the Paper Feed Tray and Delivery Tray"
• When paper misfeeds occur, select the proper paper type from [Feed Tray Pa-
per Type]. See p.52 "Printing onto Various Kinds of Paper". If the problem per-
6
sists, fan or turn the paper over.
• If the paper skews, make sure to set the paper feed side plates securely. See
p.35 "Using the Paper Feed Tray and Delivery Tray".
• Make sure originals on the exposure glass are correctly positioned and
aligned with the scale.
• If the edges of the paper are rounded, skewing might occur. Change the pa-
per's orientation or replace.
• If the paper becomes creased, make sure the correct paper type has been se-
lected in [Feed Tray Paper Type]. See p.52 "Printing onto Various Kinds of Pa-
per".
• If custom paper crease frequently, use the standard paper type.
• Adjusting the position of the print image during printing will cause the fol-
lowing prints to be dirtied. Adjust the image position after master making to
prevent this.
200