Linksys QuickVPN - PC User Manual page 32

Chapter 4
Generate the Error Condition in the System
•
Log
Failover will not occur; only an error condition
will be logged.
Network Service Detection can test a WAN port's network
connectivity by pinging the Default Gateway or a specific
IP address.
WAN1/2
Default Gateway
Select this option to ping the Default
Gateway.
ISP Host
Select this option to ping the ISP Host. Then
enter the IP address.
Remote Host Select this option to ping the Remote Host.
Then enter the IP address.
DNS Lookup Host
Select this option to ping the DNS
Lookup Host. Then enter the IP address.
Click Save Settings to save your changes, or click Cancel
Changes to undo them.
Load Balance
System Management > Dual-WAN > Load Balance
Network Service Detection
Enable Network Service Detection
Detection helps manage your connection and can report
when your connection experiences problems. To use this
service, select this option.
10/100 8-Port VPN Router
Network Service
Advanced Configuration
Retry Count
Enter the number of times the Router will
try to reconnect if the connection fails.
Retry Timeout
Enter the number of times the Router will
try to make a connection to your ISP before it times out.
When Fail Should the connection not be reestablished,
set the Router to perform one of the following actions,
Remove the Connection or Generate the Error
Condition in the System Log.
Network Service Detection can test this connection by
pinging the Default Gateway or a specific IP address.
WAN1/2
Default Gateway Select this option to ping the Default
Gateway.
ISP Host
Select this option to ping the ISP Host. Then
enter the IP address.
Remote Host
Select this option to ping the Remote Host.
Then enter the IP address.
DNS Lookup Host Select this option to ping the DNS
Lookup Host. Then enter the IP address.
Bandwidth
WAN1/2
Upstream
Enter the maximum upstream bandwidth
provided by your ISP. The default is 512 kbit/sec.
Downstream Enter the
bandwidth provided by your ISP. The default is
512 kbit/sec.
Protocol Binding
Service Select the Service you want.
If the Service you need is not listed in the menu, click
Service Management to add the new service. The Service
Management screen appears.
Service Management
maximum downstream
25