Operating the TFT5600 RKM
The TFT5600 RKM supports up to seven keystrokes for assigning up to nine devices
to hot keys.
To program a hot key:
1. Press the Programming Wizard Key.
2. Press the Prnt Scrn key.
3. Identify the device.
Table 3-1: Hot Key Programming Examples
4. Press the Enter key.
5. Select the hot key that has been assigned, to complete setup.
NOTE: To program all four examples listed in Table 3-1 would require that each example be
programmed separately. Assignment of a device is not permanent. To reassign a device,
repeat the above steps.
To select the first server on Remote Switch 1, enter 1 – 1.
To select the eighth server on Remote Switch 1, enter 1 – 8.
To select the fourth server on Remote Switch 2, enter 2 – 4.
To select the standalone server on port 8 of the Master
Switch, enter 8.
HP TFT5600 Rackmount Keyboard and Monitor (RKM) User Guide