Kenwood KVT-696 Instruction Manual page 96

Monitor with dvd receiver
Hide thumbs Also See for KVT-696:
Table of Contents

Advertisement

D .
Cannot set up the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
• Cannot set up the high pass filter.
~
Subwoofer is not set to On.
~
<Audio Setup> (page 61)
~
Preout is set to "Rear".
~
<System Setup> (page 65)
~
The Dual zone function is enabled.
~
<Zone Control> (page 86)
D
Cannot set up the subwoofer phase.
~
Subwoofer is not set to On.
~
<Audio Setup> (page 61)
~
Low pass filter is set to Through.
&?
<Crossover Network Setup> (page 62)
D .
Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear
speakers.
~
The Dual zone function is disabled.
~
<Zone Control> (page 86)
D
Cannot play audio files.
~
"CD Read" of <System Setup> (page 65) is set
to "2".
D
Cannot Folder select.
~
The Scan play or Random play function is
enabled.
D
Cannot perform Repeat play.
~
The PBC function is enabled.
D .
Cannot set up the equalizer.
• Cannot set up the crossover network.
~
The Dual zone function is enabled.
~
<Zone Control> (page 86)
D
Cannot watch the source selected as AV-OUT
in the rear monitor.
~
A source control screen is displayed in front.
~
<AV Interface Setup> (page 67)
~
"AV-OUT Graphic Output" of <AV Interface
Setup> is set to "Black".
96
KVT-696/KVT-636DVD/KVT-516/KVT-546DVD
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
D
The Touch Sensor Tone doesn't sound.
v
The preout jack is being used.
~
The Touch Sensor Tone can't be output from
the preout jack.
Tuner source
D
Radio reception is poor.
v
The car antenna is not extended.
~
Pull the antenna out all the way.
v
The antenna control wire is not connected.
~
Connect the wire correctly, referring to the
section on <INSTALLATION MANUAL>.
Disc source
D
The specified disc does not play, but another
one plays instead.
v
The specified disc is quite dirty.
~
Clean the disc.
v
The disc is severely scratched.
~
Try another disc instead.
Audio file source
D
The sound skips when an Audio file is being
played.
v
The media is scratched or dirty.
~
Clean the media, referring to the CD
cleaning of the section on <Handling discs>
(page 4).
v
The recording condition is bad.
~
Record the media again or use another
media.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kvt-636dvdKvt-516Kvt-546dvd

Table of Contents