Table of Contents
Advertisement
PowerEdge T710 Technical Guidebook
Category
Card Priority
FC4 HBA
SCSI HBA
1 GB NICs
1.
For optimal performance, it is best to alternate slot population as Slot 6, 4, and 2, before starting Slot 5,3, and1.
2.
Slot 1 should be used for 1G NIC's only preferably.
3.
T710 supports up to four 25 W maximum power each (excluding internal storage slot) and up to two 15 W for the
remainder PCI-e cards regardless of which slots are populated. This restriction applies to any PCIe cards with a
maximum power over 15 W.
13.4 Boot Order
System boot order is settable in the BIOS
14
Storage
14.1 Overview
T710 supports a 16-drive backplane for 2.5" drives and an eight-drive backplane for 3.5" drives. There
are sixteen 2.5" or eight 3.5" hot-plug capable Serial Attached SCSI (SAS) or Serial ATA (SATA) slots
with two LED indicators per slot, two Mini-SAS cable connectors for connecting the backplane to the
integrated SAS 6/iR or PERC 6/i, a 10-pin planar signal connector, and an 8-pin PDB power connector.
SAS 6/iR is only supported on the 3.5" HDD backplane.
DELL
Description
Emulex LPe12000 8Gbps
1400
FC HBA, Single Port
Qlogic QLE2462 FC4
1500
HBA, Dual Port
Qlogic QLE2460 FC4
1600
HBA, Single Port
Qlogic QLE220 FC4 HBA,
1700
Single Port
Emulex LPe11002 FC4
1800
HBA, Dual Port
Emulex LPe1150 FC4
1900
HBA, Single Port
2000
LSI2032 PCIe SCSI HBA
Intel PRO/1000VT 1G Cu
2100
Quad Port NIC
Intel PRO/1000PT 1G Cu
2200
Dual Port NIC
Broadcom 5709 IPV6 1G
2300
CU Dual Port NIC
TOE/iSOE
Broadcom 5709 IPv6 1G
2400
Cu Dual Port NIC TOE
Width
Slot Priority
x8
Gen1/x4
Slot 6,4,2,5,3
Gen2
x4 Gen1
Slot 6,4,2,5,3
x4 Gen1
Slot 6,4,2,5,3
x4 Gen1
Slot 6,4,2,5,3
x4 Gen1
Slot 6,4,2,5,3
x4 Gen1
Slot 6,4,2,5,3
x4 Gen1
Slot 6,4,2,5,3
x4 Gen1
Slot 6,4,2,5,3
x4 Gen1
Slot 6,4,2,5,3,1
x4 Gen1
Slot 6,4,2,5,3,1
x4 Gen1
Slot 6,4,2,5,3,1
Maximum
2
Cards
5
5
5
5
5
5
2
5
6
6
6
32
Advertisement
Table of Contents
