LG LWHD2400HR Owner's Manual page 11

tns_ltation
1/4 Bubbi!e
INSIDE
FOAM .......
CO,OLEiD,
_,,. OUTSiDE FENCE
IN'EAT
RADIATION
8
1,,To avoid vibration and no,i_, make sure the unit is instaUed _curely and firmly.
2, In_alll the unit where the _nlight _es not shine dkectlly on the unit.
If the unit re,_ives direct sunlight, build an awning to shade Me cabinet.
3, _ere should be no ob_acle, like a fen_, wi_in 20" which might restd_ heat radiation from the con_n_r,
4,,To prevent reducing performance, inaall the unit _ that louvers of the cabinet are not Noc_ed.
5, Install the unit a little obliquely outward not _ avoid leaking Me condoned water into the room (,a_ut 1/2"
or 1/4 bubble with level).
6. Installi Me unit with its bottom potion _~60" abo_ the fl_r level.
7,, _ufl the foam between _e top d the unit and the wall to prevent air and insects from getting into the room.
8,,The power _rd mu_ be connecCedto an inde_n_nt circuit. The green wire must be ground_.
9. Connect the drain tube to the base pan ho_ in the rear si_ if you need to drain (consult a _aler,),
Plastic hose or _uivalent may _ connected toi the drain tube.
The grille is designed to, dean the fi_er both upward and downward.
(a) (b)
A. Before attaching the front grilte to the cabin_, if _u want to puff out the fitter upward;
1. Open the inlet gdlle slightly (a).
2,,Turn inside out the front grille (a).
3. Disassemble the in_t grille from the fro,_ gnlle w_th _parating the hinged part by inserting a straight type
_rew-driver
tip (b),
4. Then, rolate the inlet grille 180 degrees ,andinsert the hooks into bottom holes d the front grille.
5,, Inert the filter and attach the front grille to the cabinet.
Bo ff you want to puff ,out the fitter downward;
The grille is akeady designed that w_j.
Owner_ Manual 1i