Color System / Panasonic Auto; 3:2 Pulldown; Xga Mode - Panasonic TH-65PF11WK Operating Instructions Manual

COLOR SYSTEM / Panasonic AUTO

Select SIGNAL from the "SET UP" menu during VIDEO (S VIDEO) input
signal mode.("SIGNAL [VIDEO]" menu is displayed.)
Press to select the "COLOR SYSTEM" or "Panasonic AUTO".
Press to select each function.
If the image becomes unstable:
With the system set on Auto, under conditions of low level or noisy
input signals the image may in rare cases become unstable. Should this occur,
set the system to match the format of the input signal.
Mode
COLOR SYSTEM Set the color system to match the input signal. When selecting "AUTO", the color system is automatically
Panasonic AUTO
(4 : 3 )
Note:
Panasonic AUTO does not function when BNC Dual Video Terminal Board (TY-FB9BD) is used.

3:2 PULLDOWN

3:2 PULLDOWN: When ON, the display attempts to reproduce a more natural interpretation of sources such as movie
pictures, which are recorded at 24 frames per second.
If the picture is not stable, turn the setting to OFF.
Notes:
When ON, this setting only affects the following signal input:
• NTSC / PAL signal input during "VIDEO (S VIDEO)" input signal.
• 525i(480i), 625i(575i), 1125(1080)/60i signal input during "COMPONENT" input signal.
Press to select "3:2 PULLDOWN".
Press to set ON/OFF.

XGA MODE

This menu is displayed when the input signal is analog (Component/PC). This unit supports three types of XGA signals
with 60Hz vertical frequency having different aspect ratios and sampling rates (1,024 × 768 @ 60Hz, 1,280 × 768 @ 60Hz,
and 1,366 × 768 @ 60Hz). Be sure to make settings in accordance with the input signal in order to achieve a more
appropriate and attractive display.
In addition, after making this setting, be sure to make each adjustment (such as "AUTO SETUP") on the "POS. /SIZE"
menu as necessary. (see page 24)
Press to select "XGA MODE".
Press to select "1024×768", "1280×768" ,
"1366×768".
selected from NTSC/PAL/SECAM, however, M.NTSC signal is not displayed properly depending on
the attached terminal board. To display M.NTSC signal, select "M.NTSC" in COLOR SYSTEM.
AUTO
Set to "4:3" to view 4:3 images in an unchanged format when Panasonic AUTO is selected.
If you would like to view 4:3 images in Just format, set to "JUST".
SET UP for Input Signals
Function
PAL SECAM M.NTSC
[ VIDEO ]
SIGNAL
3D Y/C FILTER (NTSC) ON
COLOR SYSTEM AUTO
3 : 2 PULLDOWN OFF
Panasonic AUTO (4 : 3) 4:3
NTSC
3 : 2 PULLDOWN OFF
XGA MODE 1024 × 768
41