Connections - Panasonic TH-65PF11WK Operating Instructions Manual

Connections

When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
Speakers (Optional accessories)
Speaker
terminal (R)
2
Note:
Make sure that the AC
cord is locked on both
the left and right sides.
– Cable fi xing band
Secure any excess cables with band as required.
Note:
One fi xing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.
Pass the attached cable
fi xing band through the clip
as shown in the fi gure.
1
SLOT1
Optional Terminal
Board Insert Slot
(covered)
Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
AC cord connection (see page 13)
– AC cord fi xing
Plug the AC cord into
1
1
the display unit.
Plug the AC cord until it
clicks.
2 Fix the AC cord with the clamper
which is attached to the unit.
For TH-42PF11UK, TH-58PF11UK:
Clampers are not installed to this
unit. Ensure there is suffi cient slack
in the AC cord and fi rmly bind with
the supplied cable fi xing band, etc.
To secure cables connected to Terminals, wrap the cable fi xing band around them then
pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
2
SLOT2
Dual HDMI Terminals COMPONENT/RGB IN and
(equivalent of Dual Audio IN Terminals (equivalent
HDMI Terminal Board of BNC Component Video
(TY-FB10HMD)) Terminal Board (TY-42TM6A))
(see page 12) (see page 12)
Speaker
terminal (L)
Close
Push until
t h e h o o k
clicks.
Open
2. Pull off.
1. Keep the
knob
pressed.
To loosen:
To tighten:
Push the catch
Pull
R AUDIO L
P /C /R P /C /B Y/G
R R B B
COMPONENT/RGB IN
SLOT3
From EXTERNAL
monitor terminal
on Computer
(see page 10)
1
2
2
Unplug the AC cord
Unplug the AC cord
pressing the two
knobs.
Note:
When disconnecting the AC cord,
be absolutely sure to disconnect
the AC cord plug at the socket
outlet fi rst.
Pull
AUDIO
PC IN SERIAL
From SERIAL
Terminal on
Computer
(see page 11)
1
9