Initial Selections; Selecting The Input Signal; Selecting The On-Screen Menu Language - Panasonic TH-65PF11WK Operating Instructions Manual

Initial selections

Selecting the input signal

Select the input signals to be connected by installing the optional Terminal Boards.
Notes:
• Selecting is also possible by pressing the INPUT button on the unit.
• Input terminal will not be selected if the terminal board is not installed into the SLOT.
• Select to match the signals from the source connected to the component/RGB input
terminals. (see page 39)
• In two-screen display, the same input mode cannot be selected for the main picture and
sub picture.
• Image retention (image lag) may occur on the plasma display panel when a still picture is kept on
the panel for an extended period. The function that darkens the screen slightly is activated to prevent
image retention (see page 49), but this function is not the perfect solution to image retention.

Selecting the On-Screen Menu Language

Press to select the input signal to be played back from the
equipment which has been connected to the Plasma Display.
Input signals will change as follows:
INPUT1 INPUT2A
SLOT2 is for dual input so that you can select INPUT2A or
INPUT2B for INPUT2.
INPUT2A : HDMI signal terminal in SLOT2
INPUT2B : HDMI signal terminal in SLOT2
Press the INPUT "1", "2", "3" or "PC" input mode selection
button to select the INPUT mode.
Press to switch the input mode between INPUT2A and
INPUT2B.
Press to display the SET UP menu.
Press to select OSD LANGUAGE.
Press to select your preferred language.
Selectable languages
English(UK)
Deutsch
Français
Italiano
Español
ENGLISH(US)
INPUT2B INPUT3
.......(Chinese)
.......(Japanese)
.......(Russian)
Русский
PC
+
INPUT MENU - / VOL / ENTER/
INPUT MENU
SET UP
SIGNAL
SCREENSAVER
COMPONENT/RGB-IN SELECT
INPUT LABEL
POWER SAVE
STANDBY SAVE
POWER MANAGEMENT
AUTO POWER OFF
OSD LANGUAGE
+
- / VOL / ENTER/
1/2
RGB
PC
OFF
OFF
OFF
OFF
ENGLISH ( US )
15