Installing The Sound Bar On A Wall - Sony HT-CT260 Operating Instructions Manual

Removing the stands
When the Sound Bar is to be placed
facing upward slightly or on a wall,
remove the two stands at the bottom of
the Sound Bar, as shown below.
Stand
Installing the Sound Bar
on a wall
You can install the Sound Bar on the
wall.
Notes
• Use screws that are suitable for the wall
material and strength. As a plaster board wall
is especially fragile, attach the screws
securely to a wall beam. Install the Sound
Bar on a vertical and flat reinforced area of
the wall.
• Be sure to subcontract the installation to
Sony dealers or licensed contractors and pay
special attention to safety during the
installation.
• Sony is not responsible for accidents or
damage caused by improper installation,
insufficient wall strength, improper screw
installation or natural calamity, etc.
20
US
1
Prepare screws (not supplied)
that are suitable for the holes on
the back of the Sound Bar.
more than 25 mm (1 inch)
Hole on the back of the Sound Bar
2
Fasten the screws to the wall.
The screws should protrude 6 to
7 mm (approx. 1/4 inches).
6 to 7 mm
(approx. 1/4
inches)
4 mm
(3/16 inches)
5 mm
(7/32 inches)
10 mm
(13/32 inches)
592 mm
(23 3/8 inches)