Samsung XE700T1C User Manual page 117

Recovering/Backing up the Computer
4
The data on the current hard disk is saved to the new hard
disk.
5
If the data is completely saved, open the hard disk cover at
the bottom of your computer and replace the existing hard
disk with the new one.
If you cannot open the cover at the bottom of the computer,
contact the Samsung Service Center to request assistance.
In this case, you may be charged for the relevant service.
6
Your computer is now equipped with a new hard disk.
You can use your computer with a larger hard disk capacity
with the same configuration as the old one.
(Optional)
Export Disk Image Function
If you frequently recover your computer to the default (factory)
settings, you can conveniently recover your computer after
exporting the default (factory) status disk image to an external
storage device.
1
Connect the external storage device, and then select a drive
to save to.
2
Click Run.
3
Perform the process by following the instructions to
completely save the default (factory) status disk image to the
external storage device.
Now disconnect the saved external storage device and store
it separately.
4
If your computer needs to be restored to the default (factory)
settings, connect the external storage device with the saved
image.
5
Start Recovery and click Recover. Select Factory Default
Point and click Recover. The Recover process is started.
When the recover process is finished, you can use your
computer with the default (factory) settings.
Chapter 5.
116
Troubleshooting