Table of Contents
Advertisement
4.2 Charging the rechargeable batteries in the
device
DVT3000 – DVT7000
Note
• The LFH9154 Philips rechargeable batteries can be charged in
the device. Connect the device to a computer or use an external
charger.
• Fully charge the rechargeable batteries before first use.
• A complete charging cycle takes about 2.5 hours. The computer
must be turned on when charging the batteries. If the USB port
of the computer does not supply enough power, use an external
battery charger.
1
Plug the USB connector into a USB port on your computer.
2
Insert the micro USB plug into the USB port on the bottom of the
device.
18
First steps
4.3 Power on/off
1
Slide the on/off switch on the side of the device downwards for
approximately two seconds.
The device turns on and the start-up screen is displayed.
X
2
To power off, pull down the power switch on the side of the device
again and hold for about two seconds.
Note
• The device switches itself off automatically if no key is pressed
within a pre-set period of time
OFF, page
51).
(see also chapter 9.3.4 AUTO-
Table of contents
Hide quick links:
Advertisement
Table of Contents
