How To Use The Remote Control - Philips DVT7000/00 User Manual

Note
• To ensure that the device stores the recordings on the memory
card, you must switch from the internal memory to microSD
memory card (see also chapter 9.1.1 Set file location, page
display shows a folder icon which indicates where the recordings
are currently being stored: u, v, w, x, y – internal memory,
à, á, â, ã, ä – memory card.
4.8 Pull out the stand (DVT3000 – DVT7000)
Use the stand on the rear side of the device when you stand it on a
table, for example to record a meeting. This way you can get the most
of the microphone on the rear side of the device.
1
Pull out the stand on the back of the unit.
2
Place the unit on a flat surface, such as a table.
Table of contents
4.9 Using the remote control
(DVT5500, DVT7000)
40). The The battery is already inserted in the remote control. It is protected
by a plastic strip to ensure that no power is consumed during
transportation.
1
Pull out the plastic strip from the battery compartment on the
bottom of the remote control.
4.10 How to use the remote control
Note
• Replace the battery when the remote control stops working
(see also chapter 10.3 Replacing the remote control battery
(DVT5500, DVT7000), page
• Remove the battery from the remote control if it will be stored
unused for an extended period of time.
• Used batteries and rechargeable batteries should be disposed of
at an official collection point.
54).
First steps
21