Baby Unit - Philips AVENT SCD510/00 User Manual

EngliSh
10
- If the adapters are damaged, always have them replaced with one of the original type in order
to avoid a hazard. For the correct type, see chapter 'Replacement'.
- Never use the baby monitor in moist places or close to water.
- Children should be supervised to ensure that they do not play with the appliance.
- Use and store the appliance at a temperature between 50°F (10°C) and 95°F (35°C).
- Do not expose the baby unit and parent unit to extreme cold or heat or to direct sunlight.
Do not put the baby unit and the parent unit close to a heating source.
- Never place the baby unit inside the baby's bed or playpen.
- Never cover the parent unit and the baby unit with anything (e.g. a towel or blanket).
- Always place non-recheargeable batteries of the correct type in the baby unit.
- Always place a rechargeable battery pack of the correct type in the parent unit.
- If you place the parent unit next to a transmitter or other DECT appliance (e.g. a DECT
telephone or wireless router for the internet), the connection with the baby unit may be lost.
Move the baby monitor further away from the other wireless appliances until the connection
is restored.
- Switched-on mobile phones in the vicinity of the baby monitor may cause interference with the
baby monitor.
- Radio interference is inevitable and may have an effect on the sound quality of the baby monitor.
- This baby monitor is intended as an aid. It is not a substitute for responsible and proper adult
supervision and should not be used as such.
- Take every precaution to make sure that your baby can sleep safely.
- The temperature sensor only measures the temperature in the baby room. It cannot be used
to control or adjust the temperature in the baby room.
- This monitor is not intended to be used as a medical monitor and its use should not replace
adult supervision.
preparing for use

Baby unit

You can use the baby unit corded or on non-rechargeable batteries. Even if you are going to use the
unit corded, we advise you to insert the non-rechargeable batteries. This guarantees automatic
back-up in case of power failure.
Corded operation
1 Put the large appliance plug in the baby unit and put the adapter in a power outlet (Fig. 4).
The power-on light goes on.
,
Battery operation (non-rechargeable batteries)
The baby unit runs on four 1.5V R6 AA batteries (not included). We recommend you to use Philips
LR6 PowerLife batteries or an equivalent type.
Do not use rechargeable batteries, as the baby unit does not have a charging function.
Unplug the baby unit and make sure your hands and the unit are dry when you insert the
non-rechargeable batteries.
1 Remove the lid of the compartment for non-rechargeable batteries. (Fig. 5)
2 Insert four non-rechargeable batteries (Fig. 6).
Note: Make sure the + and - poles of the batteries point in the right direction.
3 Reattach the lid. (Fig. 7)
Note: When the batteries are low, the battery light on the baby unit flashes red.