Philips AVENT SCD510/00 User Manual page 16

EngliSh
16
Question
Why does the LINK light
on the parent unit flash
red?
Why does the battery light
on the baby unit flash red?
Why does the parent unit
beep?
Why does the appliance
produce a high-pitched
noise?
Why don't I hear a sound/
Why can't I hear my baby
cry?
Why does the parent unit
react too quickly to other
sounds?
Why does the parent unit
react slowly to the baby's
crying?
Answer
The baby unit and the parent unit may be out of range of each
other. Move the parent unit closer to the baby unit, but not closer
than 3.5 feet/1 meter.
If the LINK light on the parent unit still does not start to flash, use
the reset function to reset the units to their default settings.
The baby unit and the parent unit are out of range of each other.
Move the parent unit closer to the baby unit.
The baby unit may be switched off. Switch on the baby unit.
The non-rechargeable batteries of the baby unit are running low.
Replace the non-rechargeable batteries or connect the baby unit to
a power outlet (see chapter 'Preparing for use').
If the parent unit beeps while the LINK light flashes red, the
connection with the baby unit is lost. Move the parent unit closer to
the baby unit.
If the parent unit beeps and the battery light flashes red, the
rechargeable battery pack of the parent unit is running low.
Recharge the battery pack.
The baby unit may be switched off. Switch on the baby unit.
The units may be too close to each other. Make sure the parent unit
and the baby unit are at least 3.5 feet/1 meter away from each other.
The volume of the parent unit may be set too high. Decrease the
volume of the parent unit.
The volume of the parent unit may be set too low or may be
switched off. Increase the volume of the parent unit.
The microphone sensitivity level of the baby unit may be set too
low. Increase the microphone sensitivity level with the SENSITIVITY
button on the parent unit.
The baby unit and the parent unit may be out of range of each
other. Reduce the distance between the units.
The baby unit also picks up other sounds than those of your
baby. Move the baby unit closer to the baby (but observe the
minimum distance of 3.5 feet/1 meter).
The microphone sensitivity level of the baby unit may be set too
high. Decrease the microphone sensitivity level with the
SENSITIVITY button on the parent unit.
The microphone sensitivity level of the baby unit may be set too
low. Increase the microphone sensitivity level with the SENSITIVITY
button on the parent unit.