Vqt4C31 - Panasonic HC-V10K Owner's Manual

[ECONOMY (AC)]
When about 30 minutes have passed without any operation while connecting AC adaptor
with this unit, this unit automatically turns off.
≥ This unit will not automatically turn off even if the [ECONOMY (AC)] is set to [ON] in
following cases:
j Using the USB cable for PC etc.
j PRE-REC is used
j During playback of the slide show
[QUICK START]
This unit is put into recording pause approx. 0.8 seconds after the LCD monitor is reopened.
≥ When in Quick Start Standby Mode about 60% of the power used in Recording pause
mode is being consumed, so the recording time will be reduced.
≥
Quick Start will not work if there is no SD card inserted.
≥ /
Quick Start will not work if the [SD CARD] is selected in the [MEDIA SELECT], even if there
is no SD card inserted.
≥ The LCD monitor cannot be closed when using the USB cable, so please disconnect it
from the unit.
≥ Change the mode to
1 Set [QUICK START] to [ON].
2 Close the LCD monitor.
The status indicator A flashes green and the unit
goes into Quick Start Standby Mode.
3 Open the LCD monitor.
The status indicator A lights red and the unit is put
into recording pause.
≥ Quick Start Standby Mode is canceled if
j about 5 minutes have elapsed
j mode is set to
≥ It may take some time for Automatic White Balance to adjust.
≥ In the Quick Start Mode, the zoom magnification becomes approx. 1k.
≥ When it has gone into Quick Start Standby Mode automatically with the [ECONOMY
(BATT)] (l 42)/[ECONOMY (AC)], close the LCD monitor once and open it again.
≥ Turn the unit off using the power button.
[ON]/[OFF]
[ON]/[OFF]
.
43

VQT4C31