Panasonic HC-V10K Owner's Manual page 103

About status indicator during
charging
When the status indicator is flashing at a
particularly fast or slow rate, the
following should be considered.
Flashing with approx. 4 second period
(off for approx. 2 seconds, on for approx.
2 seconds):
≥ When the battery is over discharged or the
temperature of the battery is too high or
low. It can be charged, but it may take a
few hours to complete the charging
normally.
≥ It will flash in approx. 2 second intervals
when normal charging resumes. Even in
such cases, it may start flashing in
approx. 4 second intervals until charging
is completed depending on the conditions
of use.
Flashing with approx. 0.5 second period
(off for approx. 0.25 second, on for
approx. 0.25 second):
≥ The battery is not charged. Remove the
battery from the unit, and try charging
again.
≥ Check that the terminals of the unit or
battery are not dirty or covered with a
foreign object, and connect the battery
correctly once again. If a foreign object or
dirt is present, turn off the unit before
removing.
≥ The battery or environment is at an
extremely high or low temperature. Wait
until the temperature has returned to an
appropriate level and try charging again. If
you are still unable to charge, there may
be a fault in the unit, battery or AC
adaptor.
Off:
≥ Charging has finished.
≥ If the status indicator stays off despite the
charging being unfinished, there may be a
fault in the unit, battery or AC adaptor.
Refer to page 101 for details on the
battery.
About the SD card
When disposing of or giving away the SD
card, note that:
≥ Formatting and deletion of this unit or
computer only changes the file
management information and does not
completely delete the data in the SD card.
≥ It is recommended that the SD card is
physically destroyed or the SD card is
physically formatted using this unit when
disposing of or giving away the SD card.
To physically format an SD card, connect
the unit via the AC adaptor, select
[SETUP] # [FORMAT CARD] from the
menu, and then press and hold the delete
button on the screen below for about
3 seconds. When an SD card data
deletion screen appears, select [YES],
and then follow the on-screen instructions.
/
To physically format an SD card, connect
the unit via the AC adaptor, select
[SETUP] # [FORMAT MEDIA] # [SD
CARD] from the menu, and then press
and hold the delete button on the screen
below for about 3 seconds. When an SD
card data deletion screen appears, select
[YES], and then follow the on-screen
instructions.
≥ The customer is responsible for the
management of the data in the SD card.
103
VQT4C31