Voice Recognition - Garmin GMA 350H Pilot's Manual

An optional external Play button controls the play function. Pressing
the Play button once plays the latest recorded memory block. The Play
function can also be accessed via Voice Recognition commands. Refer to the
'Voice Recognition' section for more information.
Pressing the MKR/MUTE Key during play of a memory block stops play.
If a COM signal is detected during play of a recorded memory block, play
is halted.
Pressing the Play button while audio is playing begins playing the
previously recorded memory block. Each subsequent press of the Play
button selects the previously recorded memory block.
Powering off the unit automatically clears all recorded blocks.

VOICE RECOGNITION

Voice Recognition allows the pilot (and optionally copilot) to control the
GMA 350H using spoken commands. To activate Voice Recognition, push
and hold the Push-to-Command (PTC) button while speaking a command.
When the Push-to-Command button is released, the GMA 350H will
respond.
If a command is correctly interpreted by the GMA 350H, a positive
acknowledgement chime will be played, and the pilot should verify that the
correct button selection is indicated by the triangular annunciator lights.
Alternatively, some commands will be indicated by a voice response from
the GMA 350. If the desired modes are not indicated by annunciator lights
or a voice response, the pilot should repeat the command by using the
Push-to-Command button, or by manually using the front panel controls
of the GMA 350.
If a command is incorrectly interpreted by the GMA 350H, a negative
acknowledgement tone will be played. The pilot should repeat the
command by using the Push-to-Command button, or by manually using the
190-01134-14 Rev. C
Stops Play
Marker Mute Key
Garmin GMA 350H Pilot's Guide
GMA 350H Audio Panel
21