One-year limited warranty...11 Introduction The DX-E102 is the easiest way to upgrade your computer's network speed from 10 to 100 Mbps. It supports both 10 Mbps and 100 Mbps speeds in both half-duplex and full-duplex transfer modes, using auto-negotiation technology to automatically detect the network speed.
Desktop 10/100Mb Network Card Features Your Ethernet adapter features: • Compliance with the IEEE802.3u Fast Ethernet specification (100Base-TX) • Support for full duplex flow control (IEEE 802.3x) for improved performance • Support for auto-negotiation, which automatically selects IRQ and I/O address •...
PCI card on the back panel of your computer), then remove the backplate. 5 If the bracket on the DX-E102 is too tall to fit your computer’s cased, remove the bracket and replace with the included half-height bracket.
Page 5
Installing the adapter driver Note: Driver installation is not required for Mac OS X v10.4.0 or higher. (Windows 7/Vista/XP/2000) To install the card driver: 1 Insert the DX-E102 CD into your CD or DVD drive. The Dynex PCI Adapter window opens automatically.
“Power Management.” See your computer’ s user guide for more information regarding the BIOS Setup utility and BIOS settings. Note: The LED on your DX-E102 will turn off when your computer is shut down, even when WOL is enabled. DX-E102...
3 Double-click Network adapters to display the list of network adapters.You see Dynex DX-E102 PCI 10/100Mb Network Adapter. If you see a yellow exclamation point or red X over the icon adjacent to Dynex PCI Adapter, your adapter is not installed correctly or may have a problem. Double-click Dynex PCI Adapter to read the explanation of the problem.
Verify that all the settings are correct. To ping the adapter: 1 Click Start, then click Run. The Run dialog box opens. 2 Type cmd in the Open box, then click OK. The command window opens. DX-E102...
Desktop 10/100Mb Network Card 3 Type ping xxx.xxx.xxx.xxx (where xxx.xxx.xxx.xxx is the IP address you want to ping). In this case, computer B with the IP address=192.168.0.1 is being pinged from computer A. 4 Press Enter to begin pinging. If the connection is good, you receive four “Reply from”...
Product is determined to be defective by an authorized Dynex repair center or store personnel, Dynex will (at its sole option): (1) repair the Product with new or rebuilt parts; or (2) replace the Product at no charge with new or rebuilt comparable products or parts.
Page 12
• Damage due to incorrect operation or maintenance • Connection to an incorrect voltage supply • Attempted repair by anyone other than a facility authorized by Dynex to service the Product • Products sold as is or with all faults •...