Setting The Protocol Of A Projector - Canon REALiS WUX10 Mark II D User Manual

2.5.7

Setting the Protocol of a Projector

Projectors in the Projector list will display as "Disconnected" if network settings of projectors
are changed. In this case, adjust the protocol settings of the projector labelled "disconnected"
in accordance with the changed network settings, with the following procedures.
1
Select [Protocol settings] from the [Projector] menu.
"Protocol settings" dialog will appear.
2
Select a protocol from the [Protocol] pop-up menu, and adjust the settings.
Category
IP address
Community name
(SNMP V1/V2c/V3 only)
Port number
(LV Series only)
Timeout
Password
(SNMP V3 only)
Note
- An error message will appear and settings will not be registered if a value
of an entry is invalid or insufficient. Correct it as required.
- Entries will be cancelled if [X] (Close) or [Cancel] button is clicked before
clicking the [OK] button.
3
Click [OK] when you have finished adjusting the settings.
Projector's protocol settings will be changed.
Enter an IP address of the projector, in "XXX.XXX.XXX.
XXX" form.
E n t e r a c o m m u n i t y n a m e w i t h i n 1 5 o n e - b y t e
alphanumerical characters and symbols.
Enter a port number to be used, in one-byte numbers.
Default value is set to "7142".
Enter a number of seconds to time out, from 1 to 9.
Enter a password within 8 to 15 one-byte alphanumeric
characters and symbols.
CHAPTER 2 • Routine Operation
Description
2C