Changing Projector Group Settings - Canon REALiS WUX10 Mark II D User Manual

Note
- An error message will appear and settings will not be registered if a value
of an entry is invalid or insufficient. Correct it as required.
- Entries will be cancelled if [X] (Close) or [Cancel] button is clicked before
clicking the [OK] button.
2.4.3

Changing Projector Group Settings

You can change the settings of a created "Status group" or "User group." If all conditions in a
"Status group" are deleted, it will automatically be a "User group." If more than one condition
is specified in a "User group," it will automatically be a "Status group."
Note
You can not change the settings of the "Typical group." You must create
-
a new projector group with conditions entered in necessary parameter
categories.
Change the projector group settings with the following procedures.
1
Select a projector group to change from the Projector group list, and select
[Edit] from the [Group] menu.
[Edit projector group] dialog will display.
2
Change the conditions and projector group name as required.
It will be a "Status group" if more than one condition is specified, and a "User group" if
none is specified.
3
Click [OK] when you have completed specifying the conditions.
Settings changed will be reflected in the project group.
CHAPTER 2 • Routine Operation
C5