Charging The Battery; Stopping The Charge Process - Brother 206627 User Manual

Charging the Battery

NOTE: Batteries are shipped from the factory uncharged. Brother recommends that
a complete charging cycle (following steps 1 through 3 below) be completed
before using the battery for the first time.
1. Make sure the printer is connected to an AC power outlet with the AC adapter and
power cord or a DC power cord.
2. Make sure the printer is off.
3. Press the main switch and hold it down for a few seconds until the POWER indicator
light begins to blink. This puts the printer in Charge Mode and starts the charging of
the battery.
The POWER indicator light blinks until charging is complete.
The maximum time to charge to 100% capacity is approximately 120 minutes.
When the printer finishes charging the battery, it automatically turns itself off, and the
POWER indicator light goes off.
Note that when the printer is connected to an external source of power, it will
constantly draw approximately 120 mA to trickle charge the battery.

Stopping the Charge Process

If you want to stop the printer while it is in Charge mode, press the main switch
twice quickly.
Page 39