Interface Specifications; Printing On Cut Sheets - Epson TM-U375 User Manual

Acoustic noise:
Operating:

Interface Specifications

Serial interface:
Parallel interface:
Note:
Refer to the

Printing on Cut Sheets

Use the following procedure to print on slip or validation paper.
Step Host Operation
1 Transmit the ESC c 0 Switches to cut sheet mode and waits for a cut sheet to
command.
Insert the paper.
2
3 Transmit data and
commands.
4 Transmit the FF
command.
4-8 Reference Information
Approx. 65 dB or less (Bystander position, receipt/journal printing)
RS-232 compatible
IEEE 1284 compatible (Nibble/Byte Modes)
EPSON TM-U375/U375P Specification
Printer Operation
be loaded, according to the time set by the ESC f m
n command. The VALIDATION/SLIP light blinks.
Detects the cut sheet and turns on the
VALIDATION/SLIP light.
When using slip paper, detects the slip after the set
time (t2) has passed. If the slip is not detected, re-
enters the slip waiting state. When the slip paper is
detected, feeds the slip as far as the print start
position, then redetects the slip and waits for the
print data. If the slip is not detected after feeding
the paper, re-enters the slip waiting state.
When using validation paper, detects the paper after
the set time (t2) has passed. If the paper is not
detected, re-enters the validation paper waiting
state. When the validation paper is detected, waits
for the print data.
If no cut sheet is inserted within the set time (t-1),
switches from cut sheet mode to paper roll mode
automatically.
Prints the data and feeds the paper.
After printing, ejects the paper and selects paper roll
mode. Turns off the VALIDATION/SLIP light.
for
details.