Cisco 3020 - Catalyst Blade Switch Release Note page 23

Documentation Updates
Error Message DOT1X_SWITCH-5-ERR_VLAN_ROUTED_PORT: Attempt to assign VLAN [dec] to
routed 802.1x port [chars]
Error Message UDLD-3-UDLD_IDB_ERROR: UDLD error handling [chars] interface [chars].
Error Message UDLD-3-UDLD_INTERNAL_ERROR: UDLD internal error [chars].
Error Message UDLD-3-UDLD_INTERNAL_IF_ERROR: UDLD internal error, interface [chars]
[chars].
Error Message UDLD-4-UDLD_PORT_DISABLED: UDLD disabled interface [chars], [chars]
detected.
Error Message UDLD-6-UDLD_PORT_RESET: UDLD reset interface [chars].
Error Message UFAST_MCAST_SW-3-PROC_START_ERROR: No process available for
transmitting UplinkFast packets.
Error Message UFAST_MCAST_SW-4-MEM_NOT_AVAILABLE: No memory is available for
transmitting UplinkFast packets on Vlan [dec].
Error Message VQPCLIENT-2-CHUNKFAIL: Could not allocate memory for VQP.
Error Message VQPCLIENT-2-DENY: Host [enet] denied on interface [chars].
Error Message %VQPCLIENT-2-INITFAIL: Platform-specific VQP initialization failed.
Quitting
Error Message %VQPCLIENT-2-IPSOCK: Could not obtain IP socket
Error Message %VQPCLIENT-2-PROCFAIL: Could not create process for VQP. Quitting
Error Message %VQPCLIENT-2-SHUTDOWN: Interface [chars] shutdown by VMPS
Error Message VQPCLIENT-3-IFNAME: Invalid interface ([chars]) in response.
Error Message %VQPCLIENT-3-THROTTLE: Throttling VLAN change on [chars]
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(50)SE and Later
23
OL-18274-02