Cisco 3020 - Catalyst Blade Switch Release Note page 21

Error Message %EC-5-MINLINKS_NOTMET: Port-channel [chars] is down bundled ports
([dec]) doesn't meet min-links
Explanation
bundled ports. The port channel is down. [chars] is the EtherChannel, and [dec] is the EtherChannel
group number.
Recommended Action
EtherChannel, or add more ports to the EtherChannel to create a bundle.
Error Message %PAGP_DUAL_ACTIVE-3-OBJECT_CREATE_FAILED: Unable to create [chars]
Explanation
Recommended Action
Error Message %PAGP_DUAL_ACTIVE-3-RECOVERY_TRIGGER: PAgP running on [chars]
informing virtual switches of dual-active: new active id [enet], old id [enet]
Explanation
which means that all virtual switches are in a dual-active scenario. The interface is informing virtual
switches of this, which causes one switch to go into recovery mode. [chars] is the interface. The first
[enet] is the new active ID. The second [enet] is the ID that it replaces.
Recommended Action
Error Message %PAGP_DUAL_ACTIVE-3-REGISTRY_ADD_ERR: Failure in adding to [chars]
registry
Explanation
Recommended Action
Error Message %PM-6-EXT_VLAN_ADDITION: Extended VLAN is not allowed to be configured
in VTP CLIENT mode.
Explanation
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
"Error Message Traceback Reports" section in the system message guides.
OL-18274-02
The administrative configuration of minimum links is greater than the number of
Reduce the value of the minimum-links configuration parameter for an
The switch cannot create the specified managed object. [chars] is the object name.
No action is required.
Port Aggregation Protocol (PAgP) received a new active ID on the specified interface,
No action is required.
The switch could not add a function to the registry. [chars] is the registry name.
No action is required.
The switch did not add a VLAN in VTP client mode.
Copy the message exactly as it appears on the console or in the system log.
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(50)SE and Later
Documentation Updates
21