Cisco 3020 - Catalyst Blade Switch Release Note page 12

Important Notes
•
Device Manager Notes
•
•
•
Beginning in privileged EXEC mode, follow these steps to configure the HTTP server interface:
Command
Step 1 configure terminal
Step 2
ip http authentication {aaa | enable |
local}
Step 3 end
Step 4 show running-config
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(50)SE and Later
12
Cisco IOS Release 12.2(40)SE and later
If the switch has interfaces with automatic QoS for voice over IP (VoIP) configured and you upgrade
the switch software to Cisco IOS Release 12.2(40)SE (or later), when you enter the auto qos voip
cisco-phone interface configuration command on another interface, you might see this message:
AutoQoS Error: ciscophone input service policy was not properly applied
policy map AutoQoS-Police-CiscoPhone not configured
If this happens, enter the no auto qos voip cisco-phone interface command on all interface with this
configuration to delete it. Then enter the auto qos voip cisco-phone command on each of these
interfaces to reapply the configuration.
We recommend this browser setting to more quickly display the device manager from Microsoft Internet
Explorer.
From Microsoft Internet Explorer:
1. Choose Tools > Internet Options.
Click Settings in the Temporary Internet files area.
2.
From the Settings window, choose Automatically.
3.
Click OK.
4.
Click OK to exit the Internet Options window.
5.
The HTTP server interface must be enabled to display the device manager. By default, the HTTP
server is enabled on the switch. Use the show running-config privileged EXEC command to see if
the HTTP server is enabled or disabled.
If you are not using the default method of authentication (the enable password), you need to
configure the HTTP server interface with the method of authentication used on the switch.
Purpose
Enter global configuration mode.
Configure the HTTP server interface for the type of authentication that
you want to use.
Return to privileged EXEC mode.
Verify your entries.
• aaa—Enable the authentication, authorization, and accounting feature.
You must enter the aaa new-model interface configuration command
for the aaa keyword to appear.
enable—Enable password, which is the default method of HTTP
•
server user authentication, is used.
local—Local user database, as defined on the Cisco router or access
•
server, is used.
OL-18274-02