Table of Contents
Advertisement
03
Connecting your equipment
Switching components on and off using
the 12 volt trigger
You can connect components in your system (such as a
screen or projector) to this receiver so that they switch on
or off using 12 volt triggers when you select an input
function. However, you must specify which input
functions switch on the trigger using the The Input Setup
menu on page 43. Note that this will only work with
components that have a standby mode.
HDMI
ASSIGNABLE
1 3
COMPONENT
VIDEO
ASSIGNABLE
IN
1
(DVD)
Y
P
B
P
R
Y
P
B
P
R
VSX-9140TXH
•
Connect the 12 V TRIGGER jack of this receiver to
the 12 V trigger of another component.
Use a cable with a mono mini-plug on each end for the
connection.
• The trigger maximum power is DC OUT 12 V/50 mA.
After you've specified the input functions that will switch
on the trigger, you'll be able to switch the component on
or off just by pressing the input function(s) you've set on
page 43.
Note
1 Triggered connections with up to two devices compatible with 12 volt triggers can be made with this receiver.
2 Laptops and other computers not equipped with an RS-232C port can be connected via USB port using a commercially available USB to
RS-232C converter cable (USB to serial converter cable). For instructions on COM port connections and settings, contact the manufacturer
of your computer.
36
En
1
BD IN
IN
1
IN
2
IN
3
OUT 1
(KURO
LINK)
IN
2
L
(DVR)
Y
R
P
B
ZONE2
ZONE3
DVD
TV/SAT
VIDEO
DVR
OUT
OUT
IN
IN
IN
OUT
P
R
MONITOR
OUT
MONITOR
VIDEO
OUT
S-VIDEO
12 V TRIGGER
(OUTPUT 12 V
CONTROL
IR
TOTAL 50 mA MAX)
RS-232C
IN
IN
1
IN
2
OUT
OUT
1
2
12 V TRIGGER
INPUT
Connecting a PC for Advanced MCACC
output
When using Auto MCACC (page 78) or Acoustic
Calibration EQ Professional (page 83) to calibrate the
reverb characteristics of your listening room, the 3D
graphs of the reverb characteristics in your listening
room (before and after calibration) can be checked on a
computer screen by connecting the receiver to the
computer and using a special application to transfer the
data. The various MCACC parameters can also be
checked on the computer.
OU
Use a commercially-available RS-232C cable to connect
the RS-232C jack on your computer to the 9-pin RS-232C
jack on the back panel of this receiver (the cable must be
cross type, female–female).
The software to output the results is available from the
IN
support area of the Pioneer website (http://
www.pioneerelectronics.com/PUSA/
Home+Entertainment+Custom+Install). Instructions
for using the software are also available here. If you have
any questions regarding, please contact the Customer
Support Division of Pioneer.
Please make sure your system meets the following
requirements:
• The computer must be a PC functioning with one of
the following operating systems: Microsoft
Windows
Ultimate SP1, Windows
Edition SP3 or Windows
• The monitor must have a display resolution of 800 x
600 dots (SVGA) or greater.
• The computer must be equipped with at least one RS-
232C port.
• System must have internet access.
®
Microsoft
, Windows
either registered trademarks or trademarks of Microsoft Corporation in
the United States and/or other countries.
®
Vista Home Basic/Home Premium/
®
XP Professional/Home
®
2000 Professional SP4.
2
®
®
Vista, Windows
XP and Windows
®
®
2000 are
- Quick Links:
- Rear Panel
Hide quick links:
Advertisement
Table of Contents
