Table of Contents
Advertisement
03
1
Connect the IR receiver sensor to the IR IN jack on the rear of this receiver.
Closet or shelving unit
IR receiver
2
Connect the IR IN jack of another component to the IR OUT jack on the rear of this receiver
to link it to the IR receiver.
Please see the manual supplied with your IR receiver for the type of cable necessary for the connection.
Switching components on and off using the 12 volt trigger
You can connect components in your system (such as a screen or projector) to this receiver so that they switch
on or off using 12 volt triggers when you select an input function. However, you must specify which input func-
tions switch on the trigger using the
The Input Setup menu
nents that have a standby mode.
12V TRIGGER
INPUT
12V TRIGGER
1
2
(OUTPUT 12 V
TOTAL 150 mA MAX)
%
Connect the 12 V TRIGGER jack of this receiver to the 12 V trigger of another component.
Use a cable with a mono mini-plug on each end for the connection.
After you've specified the input functions that will switch on the trigger, you'll be able to switch the component on
or off just by pressing the input function(s) you've set on
Note
! It is also possible to have the component switch not when the input function is switched, but when HDMI OUT
is switched. For details, see
HDMI Setup
on
page
Non-Pioneer
component
IR
IN
IR
OUT
IN 1
IN 2
IR
OUT
IN 1
IN 2
on
page
47. Note that this will only work with compo-
12V TRIGGER
1
2
(OUTPUT 12 V
TOTAL 150 mA MAX)
page
47.
69.
Plugging in the receiver
Only plug in after you have connected all your components to this receiver, including the speakers.
CAUTION
! Handle the power cord by the plug part. Do not pull out the plug by tugging the cord, and never touch the
power cord when your hands are wet, as this could cause a short circuit or electric shock. Do not place the
unit, a piece of furniture, or other object on the power cord or pinch the cord in any other way. Never make a
knot in the cord or tie it with other cables. The power cords should be routed so that they are not likely to be
stepped on. A damaged power cord can cause a fire or give you an electric shock. Check the power cord once
in a while. If you find it damaged, ask your nearest Pioneer authorized independent service company for a
replacement.
! Before turning on the power, check that the voltage selector switch on the receiver's rear panel is set for the
voltage in your region. If not, refer to the included "Safety Brochure" and switch it to the proper voltage.
! Do not use any power cord other than the one supplied with this unit.
! Do not use the supplied power cord for any purpose other than that described below.
! The receiver should be disconnected by removing the mains plug from the wall socket when not in regular use,
e.g., when on vacation.
! Make sure the blue u STANDBY/ON light has gone out before unplugging.
1
Plug the supplied power cord into the AC IN socket on the back of the receiver.
2
Plug the other end into a power outlet.
! After this receiver is connected to an AC outlet, a 2 second to 10 second HDMI initialization process begins.
You cannot carry out any operations during this process. The HDMI indicator in the front panel display blinks
during this process, and you can turn on this receiver once it has stopped blinking. When you set the Control
with HDMI to OFF, you can skip this process. For details about the Control with HDMI feature, see
with HDMI function
on
page
68.
43
Connecting your equipment
Control
Advertisement
Table of Contents
