• The gate with the longer travel span (opening) must be set as the primary gate (GATE 1).
• If one gate is overlapping the other, the gate that is overlapping must be connected to GATE 1 so it will start moving before the other gate; GATE 2 may need to be closed
first if there is overlap or a gate lock is being used.
• The programming can be exited at any time by pressing the RESET button. Programming times-out automatically after 60 seconds of inactivity.
DUAL GATE (LEFT-SIDE PRIMARY OPERATOR)
1
Close the gate.
2
Engage the operator by turning the release lever clockwise 180°, then turning
the key clockwise 180°.
PROGRAM OPEN
3
Press the LEARN LIMITS button
(SET OPEN LIMIT LED will blink).
4
Press the GATE 1
right button to open
the left operator.
PROGRAM CLOSE
7
When the SET CLOSE
LIMITS LED blinks,
press the GATE 2
left button to close
the right operator.
The control board beeps and the SET OPEN LIMIT and SET CLOSE LIMIT LEDs stop blinking, programming is now complete. (If the SET OPEN LIMIT LED continues to blink,
repeat programming. If the problem continues, see Troubleshooting section.)
Test the limits by pressing the SBC to open and close the gate.