Haier HCM036PB User Manual page 7

1.Remove
all
packaging material. This indudes the foam base and a/
adhesive tape homing the freezer accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials
before powering on the freezer.
AdiustiHg
Year
freezer
" Your freezer is designed for freestanding installation only. It shodd not
be recessed or built-in.
® Place the freezer on a floor strong enough to support it fully loaded.
When moving the freezer, never tilt it more than a 45-degree angle.
This could damage the compressor and the sealed system.
® If the freezer is @ted let it stand in an upright position for at [east 24
hours prior to plugging. This is to allow the refrigerant to settle.
Proper Air Cir¢ l tioH
® To assure your freezer works at the maximum efficiency it was designed
for, you should instal it in a location where there is proper air
circulation, plumbing and electrical connections.
The following are recommended clearances around the refrigerator:
Sides ............... 4" (102ram}
Top.................... 4" (102ram}
Back.................. 4" ( 102ram}