Rs-232C Port Specifications; Power Mode Status; Communication Conditions; Communication Procedure - NEC E463 User Manual

RS-232C Port Specifications

PC control of the Display
Attach an RS-232C cable cross-type (commercially available) to the supplied Din/D-Sub
RS-232C for the connections�
Note: This operation system should be used by a person who is accustomed to using
computers�

Communication conditions

Set the RS-232C communication settings on the PC to match the display's
communication conditions�
The display's communication settings are as follows:
Baud rate:
Data length:
Parity bit:
Stop bit:

Communication procedure

Send the control commands from the PC via the RS- 232C connector�
The display operates according to the received command and sends a response
message to the PC�
Do not send multiple commands at the same time� Wait until the PC receives the
response before sending the next command�

Power Mode Status

Mode LED Status
On None
Standby Red
Warming
Blinking Red
up
Power saving support automatically power on when signal appear�
Standby to power on by touch up remote or keypad power button�
9,600 bps
8 bits
None
1 bit
English-17